Page History
In the "Security" tab, you can set up permissions for accessing a Webcast in the WebcastConsumer. You can allow access only to clients connecting with certain external IP addresses, or only to clients referred by link to the Webcast from certain domains. You can configure both options, in which case both sets of conditions must be satisfied before access is granted; the IP range is checked first, then the referrer domain.
IP Range
To permit access only to clients from specific IP addresses or ranges, check the option Permit access by IP range. Then, you can enter either a single IPv4 address in the format 123.234.123.234, or an IPv4 range in the format 123.234.123.234/24. This second format is known as CIDR notation and is a short form of including a whole subnet of addresses. More information on the CIDR notation is available here: Classless Inter-Domain Routing.
...
The value entered is validated, and if valid the + button is enabled to add it to the permitted list. Invalid entries will be highlighted with a red border.
| Valid Referrer Domain | Invalid Referrer Domain |
|---|---|
|
|
You can add as many referrer domains as you wish. It is not possible to add the same value more that once. Each entry is shown beneath the entry field, and can be deleted using the✖️ within the label.
| Referrer domain with entries added |
|---|
|
| Note |
|---|
Remember to Save your entries before switching to a different tab. |
...